Electric-eel RF Manuel d'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
Model RF Manual (082610)_2-ColorREV.doc Page 4 of 16
4. Use foot switch to operate
machine while keeping good
footing and balance at all times.
DO NOT
OVERREACH.
5. Machine, foot switch and cable
should be operated by one
person only. Additional
personnel in the working area
should observe all safety
instructions.
6. ALWAYS keep all guards in
place during operation.
7. ALWAYS wear rubber-soled
non-slip shoes.
8. ALWAYS avoid direct contact of
skin, facial area and especially
eyes with drain water. Chemical
compounds used in drains can
result in serious burns and other
injuries.
9. Replace fittings, cables and any
rotating parts as soon as they
become visibly worn. Replace
any cables which become
fractured, bent, kinked, or any
other damage occurs.
10. NEVER attempt to service
equipment beyond the
recommendations of the operat-
ing instructions. All other
servicing should be referred to
qualified service personnel.
11. To maintain safe operation, use
only identical replacement parts
and cables from Electric Eel.
12. ALWAYS keep clear of rotating
cages/drums, shafts, pulleys,
belts, or other rotating parts.
GENERAL SAFETY -
ELECTRICAL
DANGER
TO PREVENT SERIOUS BODILY
INJURY AND TO AVOID DANGER
FROM ELECTRICAL SHOCK:
1. ALWAYS use a Ground Fault
Circuit Interrupter (GFCI) with a
properly grounded outlet for all
electrical cords, connections, and
parts as installed by factory and
DO NOT make any alterations.
2. NEVER use machine in damp or
wet conditions.
3. NEVER expose machine to rain.
4. THE USER SHOULD NEVER
ATTEMPT TO SERVICE THE
ELECTRICAL COMPONENTS.
For safety reasons, all electrical
replacement components should
be installed by a qualified
electrician.
5. ALWAYS disconnect the
power cord from the electrical
source before making any
adjustments or changes to
power units.
6. If an extension cord is used, the
power source MUST be equipped
with a Ground Fault Circuit
Interrupter (GFCI) and properly
grounded.
Vue de la page 3
1 2 3 4 5 6 7 8 9 ... 15 16

Commentaires sur ces manuels

Pas de commentaire