Electric-eel RF Manuel d'utilisateur télécharger pdf (Page 8)

Model RF Manual (082610)_2-ColorREV.doc Page 8 of 16

6. WITH POWER ON, in order to

feed cable, the operator must

move the feeder control lever

from NEUTRAL (the position

midway between FORWARD and

REVERSE) to the FORWARD

position, while depressing the

foot actuator. (See Figure #2

for FORWARD feeder position)

Figure 2

NOTE: The speed at which the

cable is fed initially can be

controlled by moving the control

lever toward FORWARD to

increase speed and moving back

toward NEUTRAL to slow speed.

NOTE: If the feeder control lever is

initially put in FORWARD but the

cable is not advancing, then turn

the cable tension knob in a

clockwise direction until the cable

begins to advance. (See Figure #3)

DO NOT over-tighten cable tension

knob as it may damage feeder

bearings.

Figure 3

7. Continue to automatically feed

cable until obstruction is met.

When cable begins to drag or

rotation becomes difficult, move

the lever to the NEUTRAL

position and allow tool to cut

away at the obstruction. (See

Figure #4 for NEUTRAL feeder

position)

Figure 4

DANGER:

NEVER force the cable

or tool into the obstruction. Choose

the proper feeding speed in order to

give a smooth cutting action.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Electric-eel RF Manuel d'utilisateur Page 8